View and Download Hach Sc E instrument manual online. Analysis System. Sc E Measuring Instruments pdf manual download. Hach Sc Controller User Manual – Download as PDF File .pdf), Text File .txt) or read online. Hach Sc Controller User Manual . Hach Company, – .. 37 W with 25 W sensor/network card load 24 VDCpowered sc model: 24 VDC.

Author: JoJozshura Kilkree
Country: Bolivia
Language: English (Spanish)
Genre: Love
Published (Last): 5 February 2012
Pages: 420
PDF File Size: 1.12 Mb
ePub File Size: 5.85 Mb
ISBN: 727-2-94151-468-5
Downloads: 25445
Price: Free* [*Free Regsitration Required]
Uploader: Voodoorn

Hach sc100 1720E Instrument Manual

Gasket, Neoprene, panel mount, Cat. Changing The Sensor Name Operation 4.

sc00 Page 21 Installation 3. Open the controller cover. Twist the bulb in a counterclockwise direction, pulling out slightly, until it is released from the housing. Controller Display Features Operation 4.

Table of Contents Section 1 Specifications Don’t show me this message again. Strip the insulation on the cable back 1-inch.

After all plumbing and electrical connections have been completed and checked, place the head on the body and supply power to the system. Page 38 Operation 4. Page 35 Operation 4. Check all network devices for termination or biasing settings. Section 2 General Information 2. Section 11 Limited Warranty In the event that a defect is discovered during the warranty period, Hach Company agrees that, at its option, it will repair or replace the defective product or refund the purchase price, subject to the pro-rated schedule above, excluding original shipping and handling charges.


Section 7 Troubleshooting 7. Section 7 Warranty, liability and complaints HACH LANGE GmbH warrants that the product supplied is free of material and manufacturing defects and undertakes the obligation to repair or replace any defective parts at zero cost.

Wet Verification System Startup 5. If a service contract is taken out within 6 months of purchase, the warranty period is extended to 60 months. Bracket, pipe mounting, Cat. Maximum cable length is 9. Enter text from picture: Page 23 Allow at least mm Sensor Setup Menu Operation 4. Page 30 Operation 4. Refer to Figure 29 and perform the following steps to replace the fuses: Troubleshooting Troubleshooting Table 11 presents sensor warnings displayed in the Event Log, possible causes, and corrective actions.

Figure 1 Components of a Basic System 1 5 2 4 6 sc 3 7 8 9 10 1. Mounting bracket, controller, Cat. Close and secure the cover.

Hach-Lange SC User Manual | 58 pages

Installation Electrical Installation High-voltage wiring for the controller is conducted behind the high voltage DANGER The instrument must be installed barrier in the controller enclosure. Maintenance Fuse Replacement The controller contains two mains fuses. To ensure that the protection provided by this equipment is not impaired, do not use or install this equipment in any manner other than that specified in this manual.


Hex nut 4Cat. Page of 72 Go. The controller display shows the current reading plus a secondary measurement such as temperature if connected to a single sensor, or two readings with their corresponding secondary measurement readings when two sensors are connected.

Page 6 Table of Contents Section 5 Maintenance Theory Of Operation General Information 2. Section 4 Operation 4. Mounting Foot 2Cat.


Table 1 Turbidimeter Specifications Nephelometric light scatter at 90 degrees relative to majual incident light beam. The warranty period for instruments is 24 months.

Dry Verification System Startup Two types of verifications are offered. Page 72 Visit http: Pan head screw, M6 x 1,0 x mm 4Cat. Section 4 Operation Section 4 Operation 4.