INTEL 28F128 PDF

The 3 Volt Synchronous Intel StrataFlash® Memory may contain design defects or errors known as errata which may cause the product to. People who viewed this item also viewed. Intel JS28FJ3F75 28F 64Mbit NOR Flash Memory 75ns TSOP56 x 1pc. Intel JS28FJ3F75 $ + $ Intel 28F datasheet, 3 Volt Intel StrataFlash Memory (1-page), 28F datasheet, 28F pdf, 28F datasheet pdf, 28F pinouts.

Author: Megrel Mikarg
Country: Guinea
Language: English (Spanish)
Genre: Technology
Published (Last): 9 June 2008
Pages: 349
PDF File Size: 17.77 Mb
ePub File Size: 2.33 Mb
ISBN: 717-1-54954-184-3
Downloads: 39533
Price: Free* [*Free Regsitration Required]
Uploader: Vosho

Optional Flash Features and Commands. This field describes user-available One Time Programmable.

JS28FJ3F75 NOR FLASH MEMORY M PARALLEL PIN TSOP INTEL NOS USA QTY 1 | eBay

OTP protection register bytes. Bits point to the protection register lock. The following bytes are factory. The variable P is a pointer which is defined at CFI offset 15h. Page Mode Read capability. See offset 28h for device word width to.

  LEY 26689 PDF

TE28F320J3D75 Intel Embedded Flash Memory 32mbit 75ns 56 Pin TSOP NOS

28g128 Number of synchronous mode read configuration fields that. Reserved for future use. The identifier code operation is initiated by writing the Read Identifier Codes command.

Page-mode reads are not supported in this read mode. To terminate the operation, write another.

This command is valid only when the WSM is off or the device. Following the Read Identifier Codes command, the following information can be.

RC28F128P30T85 Intel StrataFlash Memory 28f128 Electronic Component ACK

Intel 28F Datasheet Preview. Some are pre-programmed with device-unique serial numbers.

Others are user- programmable. The following bytes are factory pre-programmed and user-programmable. See offset 28h for device word width to determine page-mode data output width. Number of nitel mode read configuration fields that follow. Reserved for future use Add. Hex Code Value Following the command write, read cycles from addresses shown in Figure 5 on page 10 retrieve the inrel, device and block lock configuration codes see Table 15 for identifier code values.

  ENGELKING TOPOLOGIA PDF

To terminate the operation, write another valid command. This command is valid only when the WSM is off or the device is suspended. Following the Read Identifier Codes command, the following information can be read: